PHREEZE PHR-1765 Car Phone Holder

Want to buy car phone holders with charger? This wireless charger charges your phone faster than it runs out of battery with navigation on. You can rotate the fully automatic phone holder 90 degrees with a button. The clamps also open and close at the touch of a button! You can use this phone holder on the dashboard, windshield or ventilation grille.

• The holder opens and closes automatically using a button on the side
• The infrared sensor always charges in the right place on your phone
• With 15 watts of fast charging, you can charge your phone while you navigate
• Use it on your dashboard, windshield or ventilation grille

Infrared Sensor

Did you know that every phone has a different place where it charges wirelessly? Larger phones often have this in the middle, while smaller phones have it higher up. This phone holder uses an infrared sensor that recognizes the wireless charging chip, so you will see the sensor moving in the beginning. Once it has recognized the correct location, it will start wireless fast charging.

Automatic

The phone holder also automatically opens and closes the clamps. You can do this with a hand movement or manually using the button on the side. Do you forget your phone in the holder and your car is off? Then the holder will notify you that you have forgotten your phone!

Three ways to install

The phone holder can be installed in different ways. Ideal, because everyone has a personal preference when it comes to placing the smartphone. You can easily place the phone holder on the window, on the dashboard or in the ventilation grille.

Adjustable

You can extend the suction cup to 20 centimeters in length, but also adjust it in height up to 60 degrees. In addition, you have the ball joint, which allows you to rotate the holder 360 degrees. With the ventilation attachment you have an extra support arm so that your ventilation grille slats are not damaged. You can only rotate the attachment 360 degrees through the ball joint.

Installation

The phone holder consists of two parts that you have to click together. Click the ball joint on the base to the holder and then tighten it. Now that the phone holder is one piece, install it on your dashboard, ventilation or windshield.

For on the dashboard or windshield

• First clean the dashboard or windshield of grease and dust by using a wet cloth.
• Then remove the plastic from the suction cup and place it in the desired location.
• Press it firmly and press the button. Allow this to adhere to the windshield for 4 hours.

For in the ventilation

• Push the top of the clamp towards you until it is open
• Then place it in your air grille and release it, it will automatically clamp.
• Now position the support clamp for an optimal viewing angle
• Please note! Only fits on air grilles that are straight and horizontal. This attachment does not fit in other ventilation grilles!

Ready for use

• Now place your phone in the holder, the holder automatically clamps your phone, or press the button on the side
• Take your phone out? Press the button on the side. No more hassle with clamps!